Here comes mine
"Opinion coming: I really try not to use Solidworks, or them i will finish having a render ready, but i really want to try do it stage by stage
because if everyone render, the contest don't will be apelative from now till february, i think..."
The desing is quite simple, i try to use a layout i was trying construct inside my head:
Use RADs almost (in line with) back the board. So that way right side have at least 8 fan holes, making it compatible with both 460/480 Rad with 140/120mm fan. Using standoff from the board tray it makes possible fresh air in both RADs
So, case support:
# 2 x DVD drives
# 8 x HDD 2,5" with front 120mm fan
# 1 x 3,5" for having USB or Card Reader
# 5 x HDD 3,5" side by side with front 120mm fan
# 2 x PSU on back/top
# 2 x Phobya Extreme 200 bottom
# 2 x Pump, in a L back the Board Tray
# 2 x Phobya Balance 150
# 2 x Fillport on front/top of case (in the sketch there not in the right place, forget that position, they are to be use on the 45º Front Top zone)
# 1 CPU back acess
# Cable for board management
# Holes on Tray to see the minimum tubes, each pump are directly horizontal to CPU or GPUs
# 2 460 or 480 RAD back the board tray. The holes for power are manage in a Acrylic piece do to each board if wanted, so can be use 3mm sleeving and have the best result
# HDD Cage have a push pull fan system. The second fan helps too in hide the sata and power cables
# In the place of normal 80mm next to I/O Shield it have 2 holes, so a Phobya 1080 can be use in the Right Side, using standoffs.
# A large area back tray can be helpfull to hide and manage all cables using plastic cable clips
# Each HDD cage group can be swap from place and fan.
# Air from 460/480 Right Side RADs go out be a top exaust cut, so they never go near other components
# Both PSU pull air from outside, one from each side of case
Removing the cage for 2,5", removing the front PX200 and put up the 3,5" cage, you can use 2 more 240mm RADs using previous 3,5" fan like a air duct.
If remove the back PX200 in previous config, you can use a new 460/480 RAD + 240mm RAD on bottom, and still have the others 2 on Back of Board Tray.
Final dimension are: 265*655*620(H) yeah huge but can fit 3 480*60mm + a 240mm and a Phobya 1080 If needed
Sorry for my bad english,
Thaks for the opportunity
esta sexta-feira posto a minha caixa 
